know-how:usefull_commands
Unterschiede
Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
Beide Seiten der vorigen RevisionVorhergehende Überarbeitung | Letzte ÜberarbeitungBeide Seiten der Revision | ||
know-how:usefull_commands [2024/03/28 13:54] – [Disassociate Client hostapd/wpad] cc | know-how:usefull_commands [2024/03/28 13:55] – [List /scan wireless access points hostapd/wpad] cc | ||
---|---|---|---|
Zeile 1545: | Zeile 1545: | ||
</ | </ | ||
- | ====== List /scan wireless access points hostapd/ | + | ====== List wireless hardware capabilities hostapd/ |
+ | |||
+ | < | ||
+ | iw list | ||
+ | |||
+ | root@ilo:~# iw list | ||
+ | Wiphy phy1 | ||
+ | wiphy index: 1 | ||
+ | max # scan SSIDs: 4 | ||
+ | max scan IEs length: 2257 bytes | ||
+ | max # sched scan SSIDs: 0 | ||
+ | max # match sets: 0 | ||
+ | Retry short limit: 7 | ||
+ | Retry long limit: 4 | ||
+ | Coverage class: 0 (up to 0m) | ||
+ | Device supports AP-side u-APSD. | ||
+ | Device supports T-DLS. | ||
+ | Available Antennas: TX 0x7 RX 0x7 | ||
+ | Configured Antennas: TX 0x7 RX 0x7 | ||
+ | Supported interface modes: | ||
+ | * IBSS | ||
+ | * managed | ||
+ | * AP | ||
+ | * AP/VLAN | ||
+ | * monitor | ||
+ | * mesh point | ||
+ | * P2P-client | ||
+ | * P2P-GO | ||
+ | * outside context of a BSS | ||
+ | Band 1: | ||
+ | Capabilities: | ||
+ | HT20/ | ||
+ | SM Power Save disabled | ||
+ | RX HT20 SGI | ||
+ | RX HT40 SGI | ||
+ | TX STBC | ||
+ | RX STBC 1-stream | ||
+ | Max AMSDU length: 3839 bytes | ||
+ | DSSS/CCK HT40 | ||
+ | Maximum RX AMPDU length 65535 bytes (exponent: 0x003) | ||
+ | Minimum RX AMPDU time spacing: 8 usec (0x06) | ||
+ | HT TX/RX MCS rate indexes supported: 0-23 | ||
+ | Frequencies: | ||
+ | * 2412 MHz [1] (24.0 dBm) | ||
+ | * 2417 MHz [2] (24.0 dBm) | ||
+ | * 2422 MHz [3] (24.0 dBm) | ||
+ | * 2427 MHz [4] (24.0 dBm) | ||
+ | * 2432 MHz [5] (24.0 dBm) | ||
+ | * 2437 MHz [6] (24.0 dBm) | ||
+ | * 2442 MHz [7] (24.0 dBm) | ||
+ | * 2447 MHz [8] (24.0 dBm) | ||
+ | * 2452 MHz [9] (24.0 dBm) | ||
+ | * 2457 MHz [10] (24.0 dBm) | ||
+ | * 2462 MHz [11] (24.0 dBm) | ||
+ | * 2467 MHz [12] (disabled) | ||
+ | * 2472 MHz [13] (disabled) | ||
+ | * 2484 MHz [14] (disabled) | ||
+ | valid interface combinations: | ||
+ | * #{ managed } <= 2048, #{ AP, mesh point } <= 8, #{ P2P-client, P2P-GO } <= 1, #{ IBSS } <= 1, | ||
+ | total <= 2048, #channels <= 1, STA/AP BI must match, radar detect widths: { 20 MHz (no HT), 20 MHz, 40 MHz } | ||
+ | |||
+ | HT Capability overrides: | ||
+ | * MCS: ff ff ff ff ff ff ff ff ff ff | ||
+ | * maximum A-MSDU length | ||
+ | * supported channel width | ||
+ | * short GI for 40 MHz | ||
+ | * max A-MPDU length exponent | ||
+ | * min MPDU start spacing | ||
+ | max # scan plans: 1 | ||
+ | max scan plan interval: -1 | ||
+ | max scan plan iterations: 0 | ||
+ | Supported extended features: | ||
+ | * [ RRM ]: RRM | ||
+ | * [ CQM_RSSI_LIST ]: multiple CQM_RSSI_THOLD records | ||
+ | * [ CONTROL_PORT_OVER_NL80211 ]: control port over nl80211 | ||
+ | * [ TXQS ]: FQ-CoDel-enabled intermediate TXQs | ||
+ | * [ AIRTIME_FAIRNESS ]: airtime fairness scheduling | ||
+ | * [ SCAN_RANDOM_SN ]: use random sequence numbers in scans | ||
+ | * [ SCAN_MIN_PREQ_CONTENT ]: use probe request with only rate IEs in scans | ||
+ | * [ CAN_REPLACE_PTK0 ]: can safely replace PTK 0 when rekeying | ||
+ | * [ CONTROL_PORT_NO_PREAUTH ]: disable pre-auth over nl80211 control port support | ||
+ | * [ DEL_IBSS_STA ]: deletion of IBSS station support | ||
+ | * [ MULTICAST_REGISTRATIONS ]: mgmt frame registration for multicast | ||
+ | * [ SCAN_FREQ_KHZ ]: scan on kHz frequency support | ||
+ | * [ CONTROL_PORT_OVER_NL80211_TX_STATUS ]: tx status for nl80211 control port support | ||
+ | Wiphy phy0 | ||
+ | wiphy index: 0 | ||
+ | max # scan SSIDs: 16 | ||
+ | max scan IEs length: 199 bytes | ||
+ | max # sched scan SSIDs: 0 | ||
+ | max # match sets: 0 | ||
+ | Retry short limit: 7 | ||
+ | Retry long limit: 4 | ||
+ | Coverage class: 0 (up to 0m) | ||
+ | Device supports AP-side u-APSD. | ||
+ | Available Antennas: TX 0x7 RX 0x7 | ||
+ | Configured Antennas: TX 0x7 RX 0x7 | ||
+ | Supported interface modes: | ||
+ | * IBSS | ||
+ | * managed | ||
+ | * AP | ||
+ | * AP/VLAN | ||
+ | * monitor | ||
+ | * mesh point | ||
+ | * P2P-client | ||
+ | * P2P-GO | ||
+ | * P2P-device | ||
+ | Band 2: | ||
+ | Capabilities: | ||
+ | RX LDPC | ||
+ | HT20/ | ||
+ | SM Power Save disabled | ||
+ | RX HT20 SGI | ||
+ | RX HT40 SGI | ||
+ | TX STBC | ||
+ | RX STBC 1-stream | ||
+ | Max AMSDU length: 7935 bytes | ||
+ | DSSS/CCK HT40 | ||
+ | Maximum RX AMPDU length 65535 bytes (exponent: 0x003) | ||
+ | Minimum RX AMPDU time spacing: 8 usec (0x06) | ||
+ | HT TX/RX MCS rate indexes supported: 0-23 | ||
+ | VHT Capabilities (0x338001b2): | ||
+ | Max MPDU length: 11454 | ||
+ | Supported Channel Width: neither 160 nor 80+80 | ||
+ | RX LDPC | ||
+ | short GI (80 MHz) | ||
+ | TX STBC | ||
+ | RX antenna pattern consistency | ||
+ | TX antenna pattern consistency | ||
+ | VHT RX MCS set: | ||
+ | 1 streams: MCS 0-9 | ||
+ | 2 streams: MCS 0-9 | ||
+ | 3 streams: MCS 0-9 | ||
+ | 4 streams: not supported | ||
+ | 5 streams: not supported | ||
+ | 6 streams: not supported | ||
+ | 7 streams: not supported | ||
+ | 8 streams: not supported | ||
+ | VHT RX highest supported: 0 Mbps | ||
+ | VHT TX MCS set: | ||
+ | 1 streams: MCS 0-9 | ||
+ | 2 streams: MCS 0-9 | ||
+ | 3 streams: MCS 0-9 | ||
+ | 4 streams: not supported | ||
+ | 5 streams: not supported | ||
+ | 6 streams: not supported | ||
+ | 7 streams: not supported | ||
+ | 8 streams: not supported | ||
+ | VHT TX highest supported: 0 Mbps | ||
+ | Frequencies: | ||
+ | * 5180 MHz [36] (23.0 dBm) | ||
+ | * 5200 MHz [40] (23.0 dBm) | ||
+ | * 5220 MHz [44] (23.0 dBm) | ||
+ | * 5240 MHz [48] (23.0 dBm) | ||
+ | * 5260 MHz [52] (23.0 dBm) (radar detection) | ||
+ | * 5280 MHz [56] (23.0 dBm) (radar detection) | ||
+ | * 5300 MHz [60] (23.0 dBm) (radar detection) | ||
+ | * 5320 MHz [64] (23.0 dBm) (radar detection) | ||
+ | * 5500 MHz [100] (23.0 dBm) (radar detection) | ||
+ | * 5520 MHz [104] (23.0 dBm) (radar detection) | ||
+ | * 5540 MHz [108] (23.0 dBm) (radar detection) | ||
+ | * 5560 MHz [112] (23.0 dBm) (radar detection) | ||
+ | * 5580 MHz [116] (23.0 dBm) (radar detection) | ||
+ | * 5600 MHz [120] (23.0 dBm) (radar detection) | ||
+ | * 5620 MHz [124] (23.0 dBm) (radar detection) | ||
+ | * 5640 MHz [128] (23.0 dBm) (radar detection) | ||
+ | * 5660 MHz [132] (23.0 dBm) (radar detection) | ||
+ | * 5680 MHz [136] (23.0 dBm) (radar detection) | ||
+ | * 5700 MHz [140] (23.0 dBm) (radar detection) | ||
+ | * 5720 MHz [144] (23.0 dBm) (radar detection) | ||
+ | * 5745 MHz [149] (30.0 dBm) | ||
+ | * 5765 MHz [153] (30.0 dBm) | ||
+ | * 5785 MHz [157] (30.0 dBm) | ||
+ | * 5805 MHz [161] (30.0 dBm) | ||
+ | * 5825 MHz [165] (30.0 dBm) | ||
+ | * 5845 MHz [169] (27.0 dBm) (no IR) | ||
+ | * 5865 MHz [173] (27.0 dBm) (no IR) | ||
+ | valid interface combinations: | ||
+ | * #{ managed, P2P-client } <= 16, #{ P2P-GO } <= 3, #{ AP } <= 16, #{ IBSS } <= 1, | ||
+ | total <= 16, #channels <= 1, STA/AP BI must match, radar detect widths: { 20 MHz (no HT), 20 MHz, 40 MHz, 80 MHz, 80+80 MHz, 160 MHz } | ||
+ | |||
+ | HT Capability overrides: | ||
+ | * MCS: ff ff ff ff ff ff ff ff ff ff | ||
+ | * maximum A-MSDU length | ||
+ | * supported channel width | ||
+ | * short GI for 40 MHz | ||
+ | * max A-MPDU length exponent | ||
+ | * min MPDU start spacing | ||
+ | max # scan plans: 1 | ||
+ | max scan plan interval: -1 | ||
+ | max scan plan iterations: 0 | ||
+ | Maximum associated stations in AP mode: 0 | ||
+ | Supported extended features: | ||
+ | * [ VHT_IBSS ]: VHT-IBSS | ||
+ | * [ RRM ]: RRM | ||
+ | * [ SET_SCAN_DWELL ]: scan dwell setting | ||
+ | * [ CQM_RSSI_LIST ]: multiple CQM_RSSI_THOLD records | ||
+ | * [ CONTROL_PORT_OVER_NL80211 ]: control port over nl80211 | ||
+ | * [ TXQS ]: FQ-CoDel-enabled intermediate TXQs | ||
+ | * [ AIRTIME_FAIRNESS ]: airtime fairness scheduling | ||
+ | * [ AQL ]: Airtime Queue Limits (AQL) | ||
+ | * [ CONTROL_PORT_NO_PREAUTH ]: disable pre-auth over nl80211 control port support | ||
+ | * [ DEL_IBSS_STA ]: deletion of IBSS station support | ||
+ | * [ SCAN_FREQ_KHZ ]: scan on kHz frequency support | ||
+ | * [ CONTROL_PORT_OVER_NL80211_TX_STATUS ]: tx status for nl80211 control port support | ||
+ | |||
+ | |||
+ | </ | ||
+ | ====== List/scan wireless access points hostapd/ | ||
* WLANs anzeigen cli | * WLANs anzeigen cli | ||
know-how/usefull_commands.txt · Zuletzt geändert: 2024/03/28 13:56 von cc